Chino KP 2000 Series, Инструкция по эксплуатации

Страница: 47 / 144

- 44 -
4. Output variation limiter 8 types
①
Set 8 types of output variation limiters.
②
On the lower left, output variation limiter at the time of ascending
output and on the lower right, output variation limiter at the time of
descending output are displayed.
③
After the settings, it is necessary to set the output variation limiter
number that is to be used for each pattern/step in mode 2.
④
In case of specifications with external signal input and in case of
external signal layout 'Preset manual' layout, numbers up to No. 9
are displayed and in No. 9, variation limiter of MV (output value) at
the time of switching from automatic output operation to output
preset operation is set.
5. Second output variation limiter
①
It is displayed only in case of output 2 specifications.
②
Set output variation limiter of output 2 side.
③
On the lower left, output variation limiter at the time of ascending
output and on the lower right, output variation limiter at the time of
descending output are displayed.
6. Output during program end
[Second output specifications]
①
Sets the output value (MV) at the time of program end (END).
②
If 'CONTROL' is selected, automatic output operation (or manual
output operation) continues in final SV, until resetting (RESET) is
done.
③ If output value is set directly, that output value continues until
resetting (RESET) is done.
④ Output range is within the output limiter range.
⑤ Set it for each pattern number.
7. Output preset 8 types
①
Set 8 types of output presets.
②
Output range is within output limiter range.
③
It is necessary to set whether to use it or not for every pattern/step
in mode 2 after the settings.
④
In case of output 2 specification, this setting vale is effected first
output side only, and output side is 0% fixed.
8. Pulse cycle
[Second output specifications]
①
ON-OFF pulse type or SSR drive pulse type only is displayed.
② Set time for one cycle of output ON/OFF.
③ In output 2 specifications, do the respective settings in case of
output 2 and pulse type.
④ When setting value is changed, after end of one cycle before the
setting value that is changed, do the operation using the setting
value after the changed settings.
⑤
Generally set the highest value as far as possible that is within the
range and that does not adversely affect the controllability.