Chino KP 2000 Series, Инструкция по эксплуатации

Страница: 95 / 144

- 92 -
Function name Description
5. FAST
･
Run operation of FAST function is done using external drive signal.
･
It is a function for fast forwarding the program operation.
･
Fixed external signal input is controlled using continuous signal. The status
becomes FAST after approximately 0.5 seconds or more after switching it ON
(ON).
･
It is enabled only when 'MASTER EXT' or 'MASTER FREE' is selected in
'Program drive system' of mode 1.
･
Execution conditions and operation contents etc. are similar to 'Program
operation and run operation' in section 9.2.
6. PTN 1
PTN 2
PTN 4
PTN 8
PTN10
PTN20
・
Pattern number (PTN) is selected by external signal input.
・
Pattern number selection is based on control signal due to BCD code.
・ Fixed external signal input is controlled by continuous signal. See the example
table below, depending on the pattern number to be selected, conduct (ON)
external signal input with
○ mark. Pattern number is selected in around 0.5
seconds after conduction (ON). In addition, it is possible to select conducting
patterns except
○ mark depend on the pattern number. For example, when
select pattern No. 10, select conducting PTN8 and PTN2.
PTN
No.
9
PTN
No.
8
PTN
No.
7
PTN
No.
6
PTN
No.
5
PTN
No.
4
PTN
No.
3
PTN
No.
2
PTN
No.
1
PTN20
× × × × × × × × ×
PTN10 × × × × × × × × ×
PTN 8
○ ○ × × × × × × ×
PTN 4
× × ○ ○ ○ ○ × × ×
PTN 2 × × ○ ○ × × ○ ○ ×
PTN 1
○ × ○ × ○ × ○ × ○
PTN
No.
30
PTN
No.
29
PTN
No.
26
PTN
No.
22
PTN
No.
20
PTN
No.
17
PTN
No.
15
PTN
No.
13
PTN
No.
10
PTN20
○ ○ ○ ○ ○ × × × ×
PTN10
○ × × × × ○ ○ ○ ○
PTN 8
× ○ × × × × × × ×
PTN 4
× × ○ × × ○ ○ × ×
PTN 2 × × ○ ○ × ○ × ○ ×
PTN 1
× ○ × × × ○ ○ ○ ×
・
When BCD code with pattern number other than 0-30 is selected, the pattern
number that is selected earlier remains.
・
It is enabled only when 'EXT' or 'FREE' is selected in 'Pattern selection system'
of mode 1.
・
As an example if only pattern numbers 1-4 need to be selected, only three
external signal inputs of PTN 1, PTN 2, PTN 3, PTN 4 can be assigned.
・ Execution condition and operation contents etc are same as section 9-2
'Program operation and operation'.