Carrier Access Access Navigator, Руководство пользователя

Страница: 575 / 704

Access Navigator - Release 1.8 August 2003 18-119
CLI Language Reference
CLI Command List
Syntax:
set ip gateway <address>
Example:
set ip gateway 192.168.0.250
Example:
set ip gateway none
Set Remote Config
Purpose:
Enables and disables the downloading of configuration data to the remote terminal. The
default setting is “on”, which enables the Access Navigator to automatically download
configuration settings to the remote Access Bank II over the Carrier Access FDL
management channel. This setting allows configuration changes to be sent immediately
and provides flow-through provisioning when a remote Access Bank II is installed and
powered up. When turned off, the Access Navigator will not download any
configuration data.
NOTE:
To speed up the provisioning of remote services, temporarily turn off
remote configuration downloading to the Access Bank II. When finished, turn
remote configuration on again, and the Access Navigator will download all
changes at once. Downloading to each Access Bank II can take up to one
minute. The
status remote
command will report “FDL tx in progress” during
transmission and “FDL in service as CA FDL” when transmission is complete.
NOTE:
Use the
show remote
command to display current settings in the
Access Navigator data base.
NOTE:
The
set remote config
command only affects your ability to write
configuration settings to the remote Access Bank II data base. You can always
use the
read remote
command to display the actual remote configuration
settings whenever the Access Bank II is connected to the Access Navigator via
the DS1 link and Carrier Access FDL management is selected. (See
Provision
Remote Access Bank II on page 11-1 .)
Security:
Level 2 (operator)
Field Description
address Gateway addresses have the format
xxx.xxx.xxx.xxx
,
where each xxx is a decimal number between 0 and 255. If a
gateway address is not used, you must enter
none
for the
gateway address.