CARPENTER MODEL 93 COMPU-STRIP
Phone: 315-682-9176 Fax: 315-682-9160
Page
14
Revised 08/23/13 Website: www.carpentermfg.com E-mail: [email protected]
CARPENTER MODEL 93 COMPU-STRIP
PROGRAMMING
NORMAL MODE
cont.
LCD DISPLAY PROMPT
ACTION REQUIRED
PLEASE ENTER PULL
Select pull speed 1(maximum pulling force),2 & 3(medium pulling force),
SPEED (1 THRU 5)
4 & 5(minimum pulling force). Press
ENTER.
SPEED =
Press
AMOUNT
key. This value is the number of wires to be processed. Also allows
access to Multiple Batch Processing mode.
CHANGE
CURRENT
NOTE:
If using the multiple batch feature; during initial programming this entry can
AMOUNT
be ignored and proceed to next screen. During the actual processing this screen may
OR PRESS ENTER
be used to change the current batch total without affecting any subsequent batches.
PLEASE ENTER
The batch feature allows you to process required pieces in a single or multiple
NUMBER OF BATCHES
batch(es). To process required pieces in one batch enter “1”. Press
ENTER
.
TO
RUN
To process total amount in multiple batches, enter number of batches to process.
Press
ENTER
.
PLEASE ENTER
Enter amount of pieces to process per batch. Press
ENTER
.
AMOUNT TO PROCESS
PER
BATCH
PLEASE
SELECT
Use the arrow keys to select
BATCH
or
TOTAL
display mode. Press
ENTER.
AMOUNT TO DISPLAY
BATCH
mode will count DOWN the number of pieces per batch.
TOTAL
mode will
DISPLAY = BATCH
count
UP the number of pieces per batch. Both modes will display on the screen
BATCH TOTAL
the descending or ascending piece count of the current batch being processed. The
display will also show the current batch number being processed/total batches to be
processed.
PRESS CLEAR TO
This screen will display the running total number of pieces that have been processed
RESET TOTAL COUNTER
from the current batch sequence. This amount maybe reset to zero or left alone.
OR PRESS ENTER
Press
ENTER.
TOTAL=
ROLLER PRESSURE
Roller pressure is adjusted by turning the knobs on the front of the machine labeled LEADING STRIP PRESSURE and
TRAILING STRIP PRESSURE. The goal is to achieve enough pressure to hold the wire and remove any insulation. Too
little pressure allows the wire to slip between the Feed Rollers. Slippage may cause incorrect “slug pull” dimension. Too
much pressure may result in wire not tracking straight through the machine. You may have to adjust the pressure a couple
of times to achieve the desired grip.
AMOUNT