CARPENTER MODEL 93 COMPU-STRIP
Phone: 315-682-9176 Fax: 315-682-9160
Page
11
Revised 08/23/13 Website: www.carpentermfg.com E-mail: [email protected]
CARPENTER MODEL 93 COMPU-STRIP
PROGRAMMING
NORMAL MODE
**IMPORTANT**
DO NOT USE SHARP OBJECTS ON KEYBOARD SWITCHES. FINGER TIP PRESSURE IS SUFFICIENT.
Turn on power switch located at the left side of machine. Red LED next to NORMAL MODE wire sample will light.
LCD DISPLAY PROMPT
ACTION REQUIRED
CARPENTER MFG.
Press
ENTER.
MODEL 93 COMPU STRIP
VERSION
PLEASE PRESS ENTER
Press
TRAILING STRIP
key. This value is the length of insulation to be stripped from
the left end (trailing end) of wire.
0.00
Enter dimension. Press
ENTER.
PLEASE
ENTER
TRAIL STRIP LENGTH
PLEASE
ENTER
Enter number of strip steps. Press
ENTER. NOTE:
The Step Stripping feature
enables
NUMBER OF PULL STEPS
the user to program the Model 93 to remove the desired insulation
in a series of steps
STEPS = 1
from 1 to 9. Step
Stripping can be of benefit when doing long strips or when
processing
wire with hard to slide insulation. If more than 1 step is desired the Model 93 will
automatically calculate the amount
of insulation to be removed at each step to achieve
the overall programmed strip length.
IMPORTANT:
Caution should be used when using the Step Strip feature as the more
steps used to remove the insulation, the more the wire is shuttled back and forth
increasing the chance of wire slippage, resulting in inconsistent wire lengths.
Press
TRAILING PULL
key. This value is the distance the slug of insulation is pulled
on the trailing end of the wire
0.00
Enter dimension. For a full strip enter a value greater than the overall trailing strip
PLEASE ENTER
length. For a partial strip enter a value less than the overall trailing strip length.
TRAIL PULL LENGTH
Press
ENTER
.
Press
WIRE LENGTH
key. This value is the overall length of pieces being processed.
0.00
Enter dimension. Press
ENTER.
PLEASE ENTER
OVERALL WIRE LENGTH
TRAILING
STRIP
TRAILING
PULL
WIRE
LENGTH
