54
|
ENABLE DELAYED START TIME
1. On the control panel, verify the correct station is selected.
If necessary, press
STATION SELECT
to choose the
station (A or B).
2. Press
SETUP
.
3. Type
29
on the keypad, then press
ENTER
. “Start Enable”
displays on the screen.
4. Do one of the following:
• To enable delayed start, type
1
on the keypad,
then press
ENTER
.
• To disable delayed start, type
0
on the keypad, then press
ENTER
.
5. To exit, press
SETUP
.
DISPLAY TIME REMAINING AND STATE TIME
View the cycle time and state time remaining for both stations.
1. On the control panel, press
SETUP
.
2. Type
42
on the keypad, then press
ENTER
.
3. View current state number and time remaining for each
station on the top line.
4. View estimated cycle time remaining for each station on
the bottom line.
Actual time remaining may vary depending on the rate
of incoming water.
5. To exit, press
SETUP
.
Figure 6.14
- Enable Delayed Start Time
Figure 6.15
- Display Time Remaining and
State Time
Содержание MEDIVATOR DSD EDGE
