Cambium Networks PTP 850E, Руководство пользователя

Страница: 497 / 560

Chapter 19: Alarm Management and Troubleshooting (CLI) Performing Diagnostics (CLI)
phn-3963_008v000
Page 19-24
Parameter Description
MD Level The maintenance level of the MD (0-7).
MEG Parameters
MA ID The MA/MEG ID.
Format charString in the current release.
Name The MA/MEG name (43 characters).
Level The MEG Level (0-7).
Service The Service ID of the Ethernet service to which the MEG belongs.
CCM Interval The interval at which CCM messages are sent within the MEG.
Number of MEPs The number of MEPs that belong to the MEG.
Number of Local MEPs The number of local MEPs that belong to the MEG.
Number of MIPs The number of MIPs that belong to the MEG.
SOAM MEP Table
Parameters
MEP ID The MEP ID.
Interface Location The interface on which the service point associated with the MEP is located.
MEP Direction Up or Down.
MEP Active Indicates whether the MEP is enabled (true) or disabled (false).
MEP CCM TX Enable Indicates whether the MEP is configured to send CCMs (true or false).
CCM and LTM Priority The p-bit included in CCMs sent by the MEP (0-7).
MEP MAC Address The MAC address of the service point associated with the MEP.
MEP Lowest priority fault
alarm The lowest defect priority that can trigger alarm generation. Defects with a
lower priority will not trigger alarms.
MEP Alarm on time The amount of time that defects must be present before an alarm is
generated, in msec intervals (250-1000).
MEP Alarm Clear Time
The amount of time that defects must be absent before an alarm is cleared,
msec intervals (250-1000).
Sequence errors CCM
Frames The number of out-of-sequence CCM messages received.
CCM Messages TX The number of transmitted CCM messages.
RMEP Parameters
MepId The MEP ID of the local MEP paired with the remote MEP.
Rmep Id The remote MEP ID.