Cambium Networks PTP 850E, Руководство пользователя

Страница: 301 / 560

Chapter 12: Getting Started (CLI) Configuring the Radio Parameters (CLI)
phn-3963_008v000
Page 12-18
Configuring the Radio Parameters (CLI)
In order to establish a radio link, you must:
•
Enter radio view.
• Verify that the radio is muted (the Mute Status should be On ).
•
Configure the radio frequencies.
Note
Even if you are using the default frequencies, it is mandatory to actually configure the frequencies.
• Configure the TX level.
•
Set Mute Admin to Off .
• Verify that the radio is unmuted (the Mute Status should be Off ).
Entering Radio View (CLI)
To view and configure radio parameters, you must first enter the radio’s view level in the CLI.
To enter a radio’s view level, enter the following command in root view:
root> radio slot <slot> port <port>
The following prompt appears:
radio[1/1]>
Muting and Unmuting a Radio (CLI)
To mute or unmute the radio, enter the following command:
radio[x/x]>rf mute set admin <admin>
To configure a timed mute, enter the following command in radio view:
radio[1/1]> rf mute set admin on-with-timer timeout-value <1-1440>
When the timer expires, the radio is automatically unmuted. A timed mute provides a fail-safe mechanism for
maintenance operations that eliminates the possibility of accidently leaving the radio muted after the
maintenance has been completed. By default, the timer is 10 minutes.
Note
In contrast to an ordinary mute, a timed mute is not persistent. This means that if the unit is reset,
the radio is not muted when the unit comes back online, even if the timer had not expired.
To display the mute status of a radio, enter the following command in radio view:
radio[1/1]>rf mute show status
The following command mutes the radio:
radio[1/1]>rf mute set admin on