Cambium Networks PTP 850E, Руководство пользователя

Страница: 273 / 560

Chapter 10: Alarm Management and Troubleshooting Performing Diagnostics
phn-3963_008v000
Page 10-27
Parameter Definition
MEP ID The MEP ID.
Interface Location The interface on which the service point associated with the MEP is
located.
SP ID The service point ID.
MEP Direction In this release, only Up or Down is supported.
MEP Fault Notification
State
The initial Indicates the status of the defect SOAM state machine.
Possible values are:
•
Fng Reset – Initial state.
• Fng Defect – Transient state when a defect is detected.
•
Fng Defect Reported – The defect state is steady (stable).
•
Fng Defect Clearing
– Transient state when a defect is in the process
of being cleared.
Fng Defect Cleared – The defect has been cleared (Transient state).
MEP ActiveConnectivity
Status
Indicates whether a MEP can exchange PDU (CCM, Loopback, LTR) with its
remote MEP. A MEP with some defect or an inactive MEP cannot
exchange PDUs.
Possible values are:
• inactive – At least one of the MEPremote MEPs is enabled ( True ).in
rMEPFailed status (not discovered).
• active – All remote MEPs are discovered correctly and have an
rMEPOk status.
MEP Active Indicates whether the MEP is enabled (
True
) or disabled (
False
).
MEP CCM TX Enable Indicates whether the MEP is sending CCMs ( True/False ).
CCM and LTM Priority The p-bit included in CCMs and/or LTM frames sent by this MEP (0 to 7).
MEP Defects Reserved for future use.Indicates if a defect has been detected by the
MEP level.
RMEP List
Once you have configured at least one local MEP, all other MEPs that you
have added but not configured as local MEPs are displayed here, and are
considered to be remote MEPs.
Enabling Local MEPs
Once you have added a MEP and defined it as a local MEP, you must enable the MEP.
To enable a MEP:
1.
In the SOAM MEP page ( Figure 247 ), select the MEP you want to enable.
2. Click Edit . The SOAM MEP - Edit page opens.