Chapter 16: Quality of Service (QoS) (CLI)
Configuring Policers (Rate Metering) (CLI)
phn-3963_008v000
Page 16-25
To configure the rate meter (policer) line compensation value for an interface, go to interface view for the
interface and enter the following command:
eth type eth [x/x]>rate-meter-compensation-value set <value>
To display the rate meter (policer) line compensation value for an interface, go to interface view for the interface
and enter the following command:
eth type eth [x/x]>rate-meter-compensation-value get
Table 139
Assigning Line Compensation Value for Rate Meter CLI Parameters
Parameter
Input Type
Permitted Values
Description
value
Number
0 – 32
Policers attached to the interface use this
value to compensate for Layer 1 non-
effective traffic bytes.
The following command sets the line compensation value for policers attached to GbE 1 to 20:
eth type eth [1/1]>rate-meter-compensation-value set 20
Содержание PTP 850E
Страница 1: ...User Guide PTP 850E System Release 10 9 ...
Страница 48: ...Chapter 2 Getting Started PC Setup phn 3963_008v000 Page 2 5 Figure 10 Internet Protocol Properties Window ...
Страница 502: ...Chapter 19 Alarm Management and Troubleshooting CLI Performing Diagnostics CLI phn 3963_008v000 Page 19 29 ...