Blue Bird Coachworks 450 LXi, Руководство пользователя

Страница: 343 / 684

4-16 Audio/Video Components
450 LXi Owner Manual
~ 4-16-136 ~
Rev. “C”
Connect the VCR Control Cable -
(Model GCEB0A only) the DIRECT TV Receiver can control your VCR for unattended
recording, using the VCR Control Cable provided
Plug the VCR control cable into the rear panel VCR CONTROL jack.
Temporarily position the other end over the VCR’s remote control sensor (normally a small dark plastic window on the
VCR front panel).
The remote control sensor may be labeled or identifi ed in your VCR manual. If it is not identifi ed, scan the front of the VCR
with your VCR remote control:
1.
2.
Hold the VCR remote control about ½-inch (1.3 cm) from the front
left side.
Slowly move the remote control to the right as shown in the fi gure.
Repeatedly press the remote control’s power key on and off.
3.
4.
5.
When your VCR responds to your pressing the remote control power, note the position. Temporarily tape the emitter to the
position you marked until you verify that it works properly. 6.
Test the VCR control feature as described below.
Remove the temporary mounting tape. Attach the emitter permanently
with peel-and-stick backing. This will not interfere with normal VCR
operation. The VCR SETUP menu provides the settings to allow the
DIRECT TV® Receiver to communicate with your VCR.
Scroll through the VCR brands using the joystick and buttons.
If you cannot fi nd the correct code listed for your VCR brand, try related
brands that use the same code. Also, your VCR may respond to multiple
codes.
Use the remote control SELECT button to try each code.
Alternate between this procedure and testing the code.
7.
8.
9.
10.
11.
Test the VCR (Record/Stop) - This Record/Stop test verifi es the specifi ed brand and code that controls your VCR. Before
starting the test:
Turn the VCR power on.
Verify the VCR Control Cable is properly connected.
Insert a recordable videotape into the VCR.
Use the DIRECT TV Receiver front panel controls, rather than the remote control, to test the codes.
Test the VCR record and stop commands. If either command does not function, try other codes shown for your VCR brand. If
you are unsuccessful after trying all available codes, recheck your VCR Control Cable connections and IR emitter placement.
•
•
•
NOTE: Signals coming from the remote control at the same time as signals coming from the VCR Control
cable may provide unreliable test results.