Blue Bird Coachworks 450 LXi, Руководство пользователя

Страница: 112 / 684

4-6 Awning Operation 450 LXi Owner Manual
~ 4-6-9 ~
Rev. “C”
4-6.4.5 Remote Control Programming
Normally, your remote control will come pre-programmed.
However, if it is not, follow this procedure:
On the Control Box
To put the receiver in its programming mode,
press the PROGRAM button and hold, until the
LED lights up and then release. The Programming
Button is located on the PCB Board inside the
control box.
The receiver is now ready to memorize any
transmitter/channel for a period of one (1)
minute.
1.
•
•
UP
STOP
DOWN
CHANNEL
INDICATOR
LED
Tells Transmitter
BACK
VIEW
FRONT
VIEW
Programming
Button
On the Transmitter
Press the Programming Button on the back of the transmitter.
After one (1) minute, or once the receiver is programmed, the
LED goes off. The transmitter is now programmed.
To verify the program, press the DOWN button to make sure that
the awning is extending. If it does not, repeat the instructions
from number one (1) above.
2.
•
•
4-6.4.6 Remote Control Operation
Single channel transmitter:
Press the UP, DOWN, or STOP button.
The programmed RTS receivers are activated.
Four channels transmitter:
Select the channel of the motor module you wish to control.
The corresponding LED is blinking during 3 seconds (the channel is still memorized for 30s and then the transmitter
returns to channel 1).
Press the UP, DOWN or STOP button.
The programmed RTS receivers are activated.
Battery Life
The transmitters are fi lled with a 3V battery (type 2430) which provides about three years operation assuming 4 operations
per day. When the battery becomes discharged, the control LED no longer lights up when a command is sent, and the com-
mand is not carried out. The module has an integrated backup control under the programming button. It operates by succes-
sive presses: raising, stop, lowering, stop.
How to Change the Battery:
Remove the back cover of the transmitter with a screwdriver.
Slide the battery out of its housing by pushing it with a screwdriver.
Insert the new battery
•
•
•
•
•
•
4-6.4.7 Setting Motor Limits
IF THE AWNING DOES NOT CLOSE COMPLETELY, and there is no apparent binding of any awning components, then the fabric
has most likely stretched or shifted slightly over time. This can be easily corrected by adjusting the motor limits. This will
allow the awning roller tube to run a split second longer to draw the awning fabric in tighter.