Blue Bird Coachworks 450 LXi, Руководство пользователя

Страница: 111 / 684

4-6 Awning Operation
450 LXi Owner Manual
~ 4-6-8 ~ Rev. “C”
Wind Sensor V Control
Description
The Wind Sensor V is a single motor control designed for use on the Girard
G-2000 Automatic Awning. The unit features the wind sensor control box, the wind sensor
anemometer, and an attractive indoor, push-button wall mount switch. The Wind Sensor V Remote
includes the additional, hand-held remote control, which is electronically integrated with the
control box.
Operation
Always be sure that suffi cient 110 Volt power is supplied to the awning system for correct
functioning of all component parts (controller, anemometer, awning motor, etc.) i.e., be sure
that either the inverter is on, the generator is functioning, or the vehicle is connected to shore
power. 1.
Turn the vehicle power ON and/or turn the circuit breakers to ON.
Push the button on the Wind Sensor V control switch to EXTEND the awning. The button can be released and the awning
will continue to open until it reaches full extension. It will then stop automatically.
Push the button on the Wind Sensor V control switch to RETRACT the awning. The button can be released and the awning
will continue to retract until it is fully closed. The awning motor will then turn off automatically.
Push the button during either the extend or retract mode to STOP the awning at any desired position. The button can also
be used to change direction of the awning by pushing it twice.
Wind Sensor Function
The Wind Sensor V Controller, and the Wind Sensor V Anemometer work together to continuously monitor the wind speeds,
at any given minute, around your awning. If the actual wind speed becomes GREATER than the wind speed setting of your
controller, a two (2) second delay occurs, and a signal is sent to the awning motor to retract the awning. THE AWNING WILL
REMAIN IN THE RETRACTED POSITION UNTIL SUCH A TIME THAT IT IS ONCE AGAIN EXTENDED BY PRESSING THE BUTTON OF
THE SWITCH PANEL.
2.
3.
4.
5.
NOTE: The motor supplied with your Girard G-2000 Awning is a high torque/low RPM motor, and has
been carefully selected for its reliability and application compatibility. It is designed for intermittent use
with a rating of 4 minutes/hour. If the motor’s run-time exceeds this time period, a built-in circuit breaker
will disable the motor from operation. This condition indicates normal operation of your awning system,
and generally only occurs during excessive adjustment periods. If this condition should occur, please allow
suffi cient time (up to one hour, depending on the outside temperatures) for the motor to reset and use the
manual override feature.
Adjusting the Wind Speed Setting
The Wind Sensor V has been factory pre-set to a maximum wind speed of 22 MPH. Under no circumstances should this level
be set at higher speeds. It is recommended, however, that you become familiar with the location of your Wind Sensor Control
Box. It is usually located inside of an upper cabinet. In the event that you wish to reduce the pre-set wind speed, locate your
control box and remove the four (4) Phillips screws that secure the cover. Remove the cover and notice the small dial located
near the center of the box. This dial should be pointed at 22. The minimum setting will be approximately 12 MPH.