Blue Bird Coachworks 450 LXi, Руководство пользователя

Страница: 203 / 684

4-14 Appliances
450 LXi Owner Manual
~ 4-14-38 ~
Rev. “C”
4-14.16.4 Seasonal Storage
Seasonal storage of the unit is recommended if the unit is to be left unattended for long periods of time (typically more than
two weeks) particularly if the unit could be exposed to freezing temperatures.
Unplug or disconnect the unit from the electrical supply.
Allow water to run from the dispenser head until cool (approximately ½ gallon).
Shut off the supply of water to the dispenser.
Place a drain pan or other similar container underneath the sink.
Remove the drain cap located on the bottom of the tank and drain water (approximately ½ gallon).
Replace drain cap. Do not over tighten.
1.
2.
3.
4.
5.
6.
4-14.16.5 Cleaning
Use only a soft cloth and warm soapy water to clean the dispenser head and tank. The use of harsh cleaning agents
containing acids, alkaline and organic solvents can destroy the dispenser head and tank fi nishes.
Problem Possible Cause What to Do
Water is not hot
Unit not plugged in or electric outlet is
inoperative. Check that the unit is connected to a properly grounded electric
outlet and that circuit breakers or fuses are in good order.
Thermal overload protector has tripped Contact your In-Sink-Erator dealer for service.
Water too hot or not hot
enough Thermostat not adjusted to your taste Adjust thermostat. See Adjusting Temperature .
Water dripping from the
spout or vent:
When heating
Constantly
•
•
Low water pressure preventing the
expansion chamber from draining
properly. Unplug the unit. If the dripping stops within a few minutes,
your water pressure may not be suffi cient to properly drain the
expansion chamber.
Check that there are no obstructions in the water line reducing the
supply pressure below 20 pounds per square inch. For example: a
poorly mounted saddle valve, a clogged water fi lter (not supplied),
or a partially opened shut-off valve (not supplied).
Construction debris from water line
obstructing the faucet valve seat
causing a slow water leak. Contact your In-Sink-Erator dealer for service.
Water comes out the vent
instead of the spout. Outlet tube is blocked
Flow straightener is blocked Check that the outlet tube is not kinked, twisted or pinched.
Remove fl ow straightener from end of spout by twisting
counterclockwise. Remove any debris or scale accumulation. Soak
in a mild vinegar solution if necessary to loosen scale deposits.
Reinstall fl ow straightener by threading it on clockwise.
Water and steam spits
forcefully from spout
without turning on the
dispenser faucet. Unit is boiling Reduce water temperature. See Adjusting Temperature .
Water taste or odor
Normal start-up. Under some water conditions your unit may need a few days to
“season”. Open the dispenser faucet and run until the water is
cold. Allow the unit to reheat. Repeat several times per day over
3-4 days to season the unit.
Chlorine or contaminants in the
incoming water supply may be more
noticeable in hot water. Provide a suitable drinking water fi lter. Contact your local water
authority for suggestions.
Water does not fl ow
immediately after the
actuating handle. Normal functioning of the unit No correction needed.
CAUTION!!
Remember – do not reconnect the electrical supply unless the tank is completely fi lled with
water and water fl ows from the dispenser head.