Tools Required
When attaching the F mount, you will need a 2mm Hex driver. While it’s not absolutely required,
we recommend using a torque wrench able to accurately set a maximum torque of 0.45Nm to
reduce the potential of over tightening the screws.
2mm Hex driver
Attaching the F Mount
1
0.10
2
0.10
Place Blackmagic URSA Broadcast vertically on a
solid, clean bench top to ensure the mount can be
attached vertically. If changing from the PL to the
F mount, ensure that you have removed the PL
baffle before inserting the F mount.
Carefully place the Blackmagic URSA Mini Pro
F mount onto the camera body ensuring the
white dot is at the 2 o’clock position.
3
4
1
3
4
2
Loosely turn the four mounting screws until initial
contact is made with the shoulder of the lens mount.
Using the 2mm Hex driver, or torque wrench with
2mm Hex key, apply one full turn of pressure to
mounting screw 1, followed by one full turn to
screw 2, and repeat for screw 3 and then 4.
Continue to apply one full turn to each screw in
the sequence above until all screws have reached
the maximum torque of 0.45Nm.
NOTE
Because of the way URSA Mini Pro F mount works, a small number of F mount
lenses are not compatible.
These are Nikkor AF-S E series lenses, which do not offer mechanical iris control, and
Nikon PC-E tilt-shift lenses like the 24mm f/3.5D PC-E and 85mm PC-E.
170
Interchangeable Lens Mount
