BEYERTONE
®
www.beyertone.com
© VIII-2011 BEYERTONE GmbH
CR-200 / CR-100 USB Ver. 2-3 - Installation and User Guide
36/64
4. Playing back recordings
Recordings, that have been made with the CR-200, have to be imported from the USB
flashdrive stick to your PC or laptop by means of the CallRecorder PC software first.
To do so, and for easy searching and playback of recordings, use the
archive function
,
which is described in detail in chapter 6.
5. Standby mode
If you do not want to record your conversations temporarily, you do not need to switch
off the CR-200 completely, but you can activate the standby mode of the unit. To do so,
press the red button for approx. 2 seconds. The standby mode will be indicated by the
“Status” LED flashing green (short pulses).
To set the unit back into operation again, press the red button again for 2 seconds. The
“Status” LED will light green again. The standby mode will be memorised even when the
CR-200 is switched off and on again.
5.3 Monitor function for telephone conversations
The CR-200 unit’s integrated loudspeaker also provides you with a monitor function for
your telephone. You can use this at any time, no matter whether you are simultaneously
making a recording or not. However, a so-called ‘hands-free’ function is not possible via
the CR-200.
You use the ‘Monitor’ button on the CR-200 to turn the speaker function on and also to
select the desired volume level. Each press increases the volume by one level, of which
there are 4 in total. After you have reached the top level, if you press the button again
this switches the monitor function off.
CAUTION:
Feedback (a whistling sound) can occur if the volume level is too high. If this
happens, select a lower volume level.
NOTE:
You can also configure your CR-200 so that the monitor function is permanently
activated. You can also set the standard volume level for this. You will find details on
these settings in section 7.2.
