BEYERTONE
®
www.beyertone.com
© VIII-2011 BEYERTONE GmbH
CR-200 / CR-100 USB Ver. 2-3 - Installation and User Guide
15/64
3.2.5 Connecting by USB to your PC
(CR-100 USB)
•
Basic view / location of connections on the back of the unit enclosure:
Now create a connection between the CR-100 USB unit and your PC or laptop. To do
this, use the USB cable supplied:
1. Start up your PC or laptop and wait until the operating system has completely loaded (i.e.
until your PC is ready for use).
2. Push the square (B type) USB plug into the socket marked ‘USB’ on the CR-100 USB unit.
3. Push the flat (A type) USB plug into a free USB port on your PC / laptop.
Provided that your PC is running, a message should now appear on the screen (saying
‘New hardware component found’, or similar). Now proceed with installing the USB
driver for your CR-100 USB unit, strictly following the procedure described in section
3.3.2.
NOTE:
Your CR-100 USB unit is automatically supplied with power via the USB
connection from your PC or laptop. The correct presence of a power supply is indicated
via the green (‘Power’) LED on the CR-100 USB. If despite your PC/laptop being
switched on and the USB connection plugged in the green LED does not light up,
please note the following points:
•
Check in the system controls of your PC or laptop whether supplying power to
external devices is enabled on the USB connection you are using.
•
If necessary, use an external mains adapter (available as an optional accessory) to
supply power to the CR-100 USB, by connecting this to the ‘Power’ socket.
Handset
Line
Power USB
Control
