BECKWITH ELECTRIC M-6280A, Инструкция

Страница: 146 / 462

3–23
CapTalk – 3
CONTROL OPERATIONS
Operation Mode
Indicates the operational mode of the control Auto
or Manual (yellow).
Block Status/Limit Status/NC Status
Indicates blocks, limits and lockouts that are active.
Blocks, limits and lockouts that can be active
include:
• None (light gray)
• Block Open (green)
• Block Close (red)
• Daily Op Limit (red)
• Min Voltage Limit
• Max Voltage Limit
• NC Block (red)
• NC Lockout (red)
• THD Voltage Lockout
• THD Current Lockout

NOTE: DNP Binary input points Block Close
with Hysteresis and Block Open with
Hysteresis are available with a fixed five
second Hysteresis.
HMI Active Mode
Indicates (yellow) that the HMI menu at the control
is active. Turns off after 15 minutes of inactivity.
Close/Open Timer Status
The Close/Open Timer Status includes the following
elements:
• Mode Dependent Timer
• Open/Close Warning Delay
• Re‑Close Delay
The Mode Dependent Timer display will identify the
specific control mode limit that is currently timing
(or has timed) toward an Open or Close operation.
Depending on the "Auto/Remote Control" settings
that have been established in the control, the
operational mode dependent limit that has been
exceeded will be displayed along with the type of
timer (Definite or Inverse). The Definite Timers count
down in seconds to zero and the Inverse Timers
count down in percent to zero.
The Open/Close Warning Delay will display in
seconds the currently timing delay (Open/Close)
when timing towards an Open or Close operation.
The Re-Close Delay will display in seconds that
portion of the delay that has timed until the delay
has timed out.
When the Inverse Time is applicable indicates in
percent the amount that the timer has timed in
percent. A value of 75% would indicate that a 100
sec time delay has 25 seconds until it is timed out.
Capacitor Bank Status
Indicates the status of the Capacitor Bank switch
(Open or Closed).
The last bank status is saved at the end of the
pulse duration on a loss of power to the control. It is
reinstated when power is reapplied to the control. If
Neutral Current bank status is enabled, the Neutral
Current bank status will override the saved bank
status. The bank status can be preset from the HMI
or CapTalk.
RSSI
Indicates wireless signal strength, if active. This
feature must be supported by the modem/radio
supplied with the M-6280A.
Bank Switch Status
Indicates the status of the individual phase switch
contacts when provided (red Close, green Open).