BeaconMedaes Z MED Medical Air System, Инструкции по установке, эксплуатации и обслуживанию

Страница: 39 / 104

A-5
Z MED Medical Air System
4107 9022 67.00
Appendix A - Central Control System
A.5.2 ES-6 Controls
The ES-6 indicates which commands are active
(See 2 in FIG A.5). Three symbols can appear
in this window and the table (see Fig A.5.2)
gives an overview of all control statuses and
corresponding designations.
FIG A.5.2 Controls Status Symbols
Symbol Description
On the left side the following symbols can appear
ES-6 LOCAL START/STOP
Indicates the ES-6 can be started or stopped from the Elektronikon module by
using the start and stop buttons on the control panel.
ES-6 REMOTE START/STOP
The ES-6 can be started and stopped remotely by a switch.
A switch needs to be connected and configured. If this symbol appears the ES-6
is in remote start/stop operation. The start/stop buttons on the Elektronikon
module of the ES-6 are not active
ES-6 LAN START/STOP
The ES-6 is started and stopped over a LAN network. The commands can be giv-
en over a fieldbus interface (Modbus, Profibus) connected to the LAN network.
In the middle the following symbols can appear
ES PRIORITY SCHEME 1
Shows that priority scheme 1 is active. The priority scheme gives a priority to the
connected compressors.
ES PRIORITY SCHEME 2
Shows that priority scheme 2 is active. The priority scheme gives a priority to the
connected compressors.
On the right side the following symbols can appear
ES-6 WEEK TIMER ACTIVE
The week timer is active, programmed via the clock function commands (switch-
ing pressure band, system start/stop,…) will be executed based on the timer
clock.
ES-6 AUTOMATIC RESTART AFTER VOLTAGE FAILURE (ARAVF)
FUNCTION ACTIVE
When power fails and recovers within a specific time the ES-6 will automatically
restart.