Baxall Pyramid 2, Инструкция по установке и эксплуатации

Страница: 48 / 72

Page 48
Pyramid 2 Keyboard Installation and Operating Instructions
SETTING UP A SEQUENCE
An operator with access rights to the matrix menu system can program new sequences which can then be run using the
Pyramid 2 Keyboard (see Recalling a Sequence on page 18).
An operator can store up to 16 sequences, each with 16 cameras. In doing so, you select a sequence number, the sequence
of cameras and the dwell time for each camera.
To program a new sequence, follow the steps below:
1. Access the menu system for the matrix on which the new sequence is to be stored - see
Accessing the Matrix Menu
System on page 43.
The matrix menu system is displayed on the selected monitor.
2. Select the Set sequence menu item.
3. From the resulting menu, select Define sequence . A list of the 16 sequences is displayed.
4. Select the sequence that is to be programmed. An old unused sequence can be edited, but it is important to make sure
not to select a sequence that has already been set up and that is still used on site.
The
Current Sequence List is displayed. When an unused sequence is selected, the list has only one item, which
allows the operator to programme the first camera to the sequence. If a previously used sequence is selected, the
current sequence is displayed, which can be re-programmed.
2
Define sequence
Clear sequence
3
2.1
Sequence 1
Sequence 2
Sequence 3
Sequence 4
Sequence 5
Sequence 6
Sequence 7
Sequence 8
Sequence 9
4
2.1.3
01: ..................................
5
Figure 66 - Programming a Sequence (Stage 1)
5. Select the sequence entry that is to be programmed.
6. In the
Video Source Range menu, select the range that contains the camera that is to be added to the sequence. For
example, if camera 3 is to be added, select Video Source 1-10 .
7. From the resulting menu, select the camera that is to be added to the sequence.
8. The
Dwell Time menu is displayed. At this point, the Text Editor screen is automatically displayed on the Pyramid 2
Keyboard. Enter the required dwell time (between 1 and 255 seconds) and then press the Enter soft-key.
2.1.3.1
Video source 1-10
Video source 11-20
Video source 21-30
Video source 31-40
Video source 41-50
Delete video source
2.1.3.1.1
001: Camera 1
002: Camera 2
003: Camera 3
004: Camera 4
005: Camera 5
006: Camera 6
007: Camera 7
008: Camera 8
009: Camera 9
2.1.3.1.1.1
Enter dwell time
1-255
- - -
Figure 67 - Programming a Sequence (Stage 2)
6 7
8
9. At this point, the monitor returns to Current Sequence List . Repeat steps 5 to 8 until the desired sequence is in place.