en_BA_OxE7
_PosCon3D.docx
59/64
Baumer Electric AG
17.07.2014 14:21/tof V1.01 ANW_81125407
Frauenfeld, Switzerland
7
Safety instructions and maintenance
7.1 General safety instructions
Intended use
This product is a precision device and is used for object detection and the preparation and/or provision of
measuring values as electrical quantities for a subsequent system. Unless this product is specially labeled, it
may not be used for operation in potentially explosive environments.
Commissioning
Installation, mounting and adjustment of this product may be performed only by a qualified person.
Installation
For mounting, use only the mechanical mountings and mechanical mounting accessories intended for this
product. Unused outputs must not be wired. In cable versions with unused cores, these cores must be
insulated. Always comply with admissible cable bending radii. Prior to electrical connection of the product, the
system must be disconnected from the power supply. In areas where shielded cables are mandatory, they
must be used as protection against electromagnetic disturbances. If plug connections to shielded cables are
made by the customer, an EMC version of the connectors should be used, and the shield must be connected
to the connector housing across a large area.
7.2 Laser class
The sensor must be used in accordance with laser class 1, corresponding safety precautions must be
observed.
7.3 Influence of ambient light
Ambient light from lamps, the sun, etc. in the view field of the sensor can lead to malfunctions or a reduction
of accuracy and should be avoided as much as possible.
7.4 Front (optics)
In case the front (optics) or the display pane breaks, the sensor must be immediately disconnected from the
power supply and may be restarted only by an authorized service company.
Содержание PosCon3D
Страница 1: ......
