Baumer IO-Link RR30, Инструкция по эксплуатации

Страница: 16 / 40

en_BA_RR30_IO-Link_V0.23.docx 16/40 Baumer Electric AG
13.01.2021/ Frauenfeld, Switzerland
4.3.7.1
Response Delay Time
The response delay time defines the time, the measurement value needs to be above (single point mode) or
inside (window mode) the switch points of the related SSC until its status changes to active (or inactive, if the
logic is inverted as described in section 4.3.4)
When to apply?
-
To avoid the detection of small peaks/false switching operations due to structure changes of the
background or similar.
-
To avoid wrong switching of known disturbances such as the wheel of a mixer
-
To avoid bouncing.
-
To optimize the timing of the execution of a subsequent actor triggered by the output of the sensor.
Figure 19: Response Delay
Parameter name Short Description Rights Unit /
Allowed
values
Response Delay.SSC1 Time
Sets / indicates the response delay
time in milliseconds for the
respective switching signal channel
(SSC). rw 0 to 60000 ms
Default: 0 ms
4.3.7.2
Release Delay Time
The release delay time defines the time, where the measurement value needs to be below (single point) or
outside (window mode) of the switch points of the related SSC, until its status is changed to inactive (or
active, if the logic is inverted as described in section 4.3.4)
When to apply?