Avocent MERGEPOINT 53XX SP MANAGER, Инструкция по установке и эксплуатации

Страница: 92 / 204

78
MergePoint Service Processor Manager SP53XX Installer/User Guide
To limit which IP address can create Native IP connections, administrators can specify IP
addresses in a Native IP trust. The IP addresses within the trusts are permitted to create Native
IP connections to some or all service processors.
• Administrators set up Native IP connections, which are permanent outbound connections that
allow service processors to directly connect to specific trusted IP addresses. If Selective mode
is not enabled, each IP address should be included in at least one Native IP trust.
Additionally, users with appropriate access rights may establish temporary, individual IP trusts
from their workstations to a specific service processor. Temporary trusts are automatically
disabled once the web session ends.
• Add a route or set the MergePoint SP manager IP address as the default gateway for the host.
Native IP operations using the web interface
To enable Selective mode (to trust all clients):
1. In the side navigation bar, select the MergePoint SP manager.
2. Click Network - Native IP Connects.
3. The Selective Mode status is displayed. Click Start.
To create Native IP trusts (to specify which clients are trusted):
1. In the side navigation bar, select the MergePoint SP manager.
2. Click Network - Native IP Trusts.
3. Click Add.
4. In the IP field, enter a range of trusted IP addresses.
NOTE: The Native IP trust address should be the address of the subnet itself, which means all of the host bits of
the address are 0 (zero).
5. Enter a subnet mask and select an interface for the Native IP.
6. Click Apply.
To delete a Native IP trust:
1. In the side navigation bar, select the MergePoint SP manager.
2. Click Network - Native IP Trusts.
3. Select the Native IP you want to delete and click Delete.
NOTE: When a trust is deleted, any related Native IP connections are disabled.
To set up a permanent Native IP connection:
1. In the side navigation bar, select the MergePoint SP manager.
2. Click Network - Native IP Connects.
3. Click Add.