Avocent MERGEPOINT 53XX SP MANAGER, Инструкция по установке и эксплуатации

Страница: 91 / 204

Chapter 5: Accessing Target Devices Using DirectCommand or Native IP
77
NOTE: Close any other open network applications, such as VNC, to avoid a port number conflict.
To enter the vMedia Session interface:
1. In the side navigation bar, click a target device name.
2. Click the DirectCommand tab.
3. If DirectCommand is not already connected, click Connect.
4. Click vMedia Session.
-or-
In the Top Option bar, click Connected. Select the alias of the desired target device, then click
vMedia Session.
To disconnect DirectCommand:
1. In the side navigation bar, click a target device name.
2. Click the DirectCommand tab.
3. Click Disconnect.
-or-
In the Top Option bar, click Connected. Select the alias of the desired target device, then click
Disconnect.
NOTE: For RASII target devices, the vKVM session interface and vMedia session interface are in the same
page.
NOTE: When launching a session via DirectCommand, the target device may return unexpected results due to
service processor instability. If this occurs, reset the service processor by connecting to the service processor
console from the Console - SP Console menu and running the reset service processor command. The reset
service processor command varies for each target device type; for example, for RSAII devices, the reset service
processor command is resetsp. See Device console and service processor console on page 59 and Profile
Configuration on page 172.
Native IP
NOTE: Native IP is supported on MergePoint SP5324/SP5340 appliances only.
The Native IP configuration process includes these steps:
• To allow any IP addresses on the network to create Native IP connections, administrators can
enable Selective mode. Selective mode creates an open trust (0.0.0.0/0) that frees the
connection pathway to trust any client to make a Native IP connection.
-or-