Avocent MERGEPOINT 53XX SP MANAGER, Инструкция по установке и эксплуатации

Страница: 100 / 204

86
MergePoint Service Processor Manager SP53XX Installer/User Guide
Exit
Back
NOTE: If you select Start Telnet session or Start SSH session, you are prompted for the corresponding port, and
then required to enter the username and password.
NOTE: The Enable native IP and Disable native IP commands are only supported on the MergePoint SP5324/
SP5340 appliance.
MgpShell
After logging in MergePoint SP manager console via SSH command or SSH applications as an
admin user, typing
mgpshell
and pressing the Enter or Return key brings up a list of devices you
are authorized to access, as shown in the following example.
Select a device
IBM Blade Center
HP Blade System
HP iLO/iLO2
Exit
After a device is selected, a submenu lists the device management actions available to the user. See
User shell on page 85 for details.
SSH Passthrough
SSH Passthrough allows you to perform management operations on target devices without having
to log into the MergePoint SP manager first. You may establish an SSH connection to a target
device by specifying the appropriate name in the SSH command. When opening an SSH
passthrough connection to a supported device, you may include an service processor command at
the end of the SSH command. If the service processor command is not present at the end of the
SSH command, the MergePoint SP manager will provide the user with a menu of service processor
commands to choose from.
SSH Passthrough commands
There are two types of SSH commands: commands without an service processor command and
commands with an service processor command.
To access a target device through SSH Passthrough:
Run the command by entering the following:
ssh –t userA:serverB@applianceC
.
NOTE: In this example, a user (userA) is trying to access a target device (serverB) that is connected to a
MergePoint SP manager (applianceC).