Avocent MERGEPOINT 53XX SP MANAGER, Инструкция по установке и эксплуатации

Страница: 33 / 204

Chapter 2: Installation and Setup
19
b. In the Source IP/mask field, type a source IP and subnet mask in the form: hostIPaddress
or networkIPaddress/NN.
c. In the Destination IP/mask field, type a destination IP and subnet mask in the form:
hostIPaddress or networkIPaddress/NN.
d. In the Input interface or Output interface drop-down menu, select an input or output
interface depending on which chain you select.
e. In the Fragments drop-down menu, choose the type of packets to be filtered.
f. In the Rule target drop-down menu, select a target.
4. Click Apply.
To edit a packet filtering (firewall) rule:
1. Click Network - Firewall.
2. Select the rule you want to change.
3. Modify the fields as needed.
4. Click Apply.
To delete a packet filtering (firewall) rule:
1. Click Network - Firewall.
2. Select the rule you want to delete and click the corresponding Delete button.
NOTE: Rules may also be changed using the CLI utility. See related CLI commands on page 118.
BMC Provisioning (IPMI Targets Only)
The default status of the BMC on a target device is disabled and should be provisioned before it can
be discovered by the MergePoint SP manager.
The MergePoint SP manager provides a PXE (Preboot Execution Environment) based solution for
provisioning the BMC and can be configured to automatically provision the IPMI BMC of a target
device.
There are two modes of provisioning available: dynamic and static. For static provisioning, when
the SP manager receives a PXE request from a target device, it can obtain its MAC address from
the request and use it for comparison with the MAC address and IP address pairs in the static
provisioning table. If a MAC address in the table meets this request, the MergePoint SP manager
will assign the corresponding IP address to the target device.
Dynamic provisioning occurs when no match is found and the MergePoint SP manager selects an
IP address from a specified range for the target device.
Once you have provisioned the BMC successfully, the target device is automatically initialized
with the specified provisioning parameters and added to the Managed Targets list and side
navigation bar where it can then be accessed with the MergePoint SP manager.