Avocent MERGEPOINT 53XX SP MANAGER, Инструкция по установке и эксплуатации

Страница: 136 / 204

122
MergePoint Service Processor Manager SP53XX Installer/User Guide
spmanager server After using the add command to configure a device, use the set command to configure
the parameters such as account_verify, type, ip, group, alias, user, password or sol port.
The account_verify “yes” indicates that the server is added with user account verification;
while the account_verify “no”indicates that the server is added without user account
verification.
Synopsis: set spmanager server <devicename> account_verify <yes|no> ip <server_IP>
group <server-group> alias <alias_name> user <username> password <pwd> sol_port
<port>
Example: set spmanager server 172.26.25.121 account_verify no type ilo ip
172.26.25.121 user root password admin sol_port 9500
set spmanager server 172.26.25.121 account_verify yes user root password admin
NOTE: You can set an unverifed server to a verified server; but you cannot set a verified
server to an unveified server.
See the add command for the following second level spmanager parameter: server on
page 109.
spmanager user After using the add spmanager user command to configure a user, use the set user
command to configure the user’s parameters: role and target.
Synopsis: set spmanager user <name> role <role name> target <target>
Example: set spmanager user user11 role operator target 172.26.25.179
NOTE: The range of a role name is admin, operator, user and user defined role(s). To add
a user role, see the add spmanager global role command in Table 7.2 on page 108.
See the add command for the following second level spmanager parameter: user on page
110.
spmanager global
role After using the add spmanager global role command to add a user role, use the set
command to configure the user role’s privileges -the device management actions.
Synopsis: set spmanager global role <name> privilege power <yes|no> coldest <yes|no>
directcommand <yes|no> pxe <yes|no> snmp <yes|no> lan <yes|no> user <yes|no> alert
<yes|no> sol <yes|no> bmctime <yes|no> sel <yes|no> sensor <yes|no> spconsole
<yes|no> devconsole <yes|no> rdp <yes|no>
Example: set spmanager global role role_aa privilege power yes pxe yes
NOTE: See the add command for the following second level spmanager parameter: global
role on page 110.
sshd protocol Use the set sshd protocol command to set the SSHD protocol version to either 1 or 2 or
both (1,2 or 2,1). Default is 2,1.
Synopsis: set sshd protocol <1|2|1,2|2,1> rootlogin <yes|no> port <num>
Example: set sshd protocol 1 rootlogin no port 22
NOTE: Using this command is not recommended. Changed SSHD protocol version or
SSHD port may cause some features from the web interface to fail.
Table 7.3: Setting Top Level CLI Parameters (Continued)
Parameter Command