Avocent MERGEPOINT 53XX SP MANAGER, Инструкция по установке и эксплуатации

Страница: 134 / 204

120
MergePoint Service Processor Manager SP53XX Installer/User Guide
network st_routes After using the add command to add a static route to the routing table, use the set
command to configure the static route.
Synopsis: set network st_routes <ip> [gateway <ip>] [device <interface name>][metric
<num>]
Example: set network st_routes 1.1.1.1 device eth2 metric 0
NOTE: See the add command for the following second level parameter: st_routes on page
108.
ntp server Use the set ntp command to specify an internet time server to sychronize.
Synopsis: set ntp server <ip or hostname>
Example: set ntp server clock.redhat.com
ntp enabled Use the set ntp command to run the ntp server.
Synopsis: set ntp enabled <yes|no>
Example: set ntp enabled yes
pxe mapping Use the set command to specify an IP address for added MAC.
Synopsis: set pxe mapping <mac> ip <ip-address>
Example: set pxe mapping 00602e01d9a6 ip 2.2.2.2
NOTE: See the add command for the following parameter: pxe on page 108.
pxe setting Use the set command to configure pxe settings.
Synopsis: set pxe setting subnet <subnet> netmask <mask> gateway <gateway>
sp_user <user name> sp_pwd <password> range_low <ip_address> range_high
<ip_address> vlan_enable <yes|no> vlan_id <num> vlan_priority <num>
Example: set pxe setting subnet 343 netmask 255.255.255.0 gateway 2.2.2.2 sp_user
usr1 sp_pwd dff range_low 1.1.1.1 range_high 1.1.1.5 vlan_enable yes vlan_id 3
vlan_priority 2
snmpd access After using the add snmpd command to add access, use the set snmpd command to
configure the parameters.
Synopsis: set snmpd access
Example: set snmpd access
NOTE: See the add command for the following second level snmpd parameter: access on
page 109.
snmpd com2sec After using the add snmpd command to add com2sec, use the set snmpd command to
configure the parameters.
Synopsis: set snmpd com2sec<name> context <context> source <src> name <words>
Example: set snmpd com2sec mp1 context contxt source 123.23.1.1 name mp
NOTE: See the add command for the following second level snmpd parameter: com2sec
on page 109.
Table 7.3: Setting Top Level CLI Parameters (Continued)
Parameter Command