Avocent MERGEPOINT 53XX SP MANAGER, Инструкция по установке и эксплуатации

Страница: 39 / 204

Chapter 2: Installation and Setup
25
To configure the DHCP relay server:
1. Click Targets - DHCP.
2. In the Status area, select Enable to activate DHCP relay.
3. In the Sever field, enter the IP address or the name of the DHCP relay server.
4. Click Apply.
NOTE: DHCP settings may also be changed using the CLI utility. See the related CLI commands on page 117.
Discovering and Adding Target Devices (Admin users only)
You can configure the MergePoint SP manager web interface to discover target devices that reside
on the same LAN as the appliance by specifying one or more IP address ranges either for automatic
or manual discovery. Discovered target devices are displayed in the Unmanaged Targets list, where
you can select them for additions to the Managed Targets list. You can also manually add a target
device if you know its IP address.
You may designate up to two IP address ranges for discovery. The first time you access the Targets
window the IP address ranges are blank and may be modified by clicking Edit.
NOTE: For most of the target device types, you can view the target device types from the Type column in the
Unmanaged Targets list. In a few cases, the target device types cannot be recognized until the target devices are
managed and verified. For more details, see Target Device Types Displayed in the Managed/Unmanaged
Targets Lists on page 28.
NOTE: Set RSA II devices to broadcast mode to avoid MergePoint SP manager discovery errors.
Discovering target devices
To discover target devices:
1. Click the Targets tab, then click Targets in the top navigation bar.
2. Select Discovery Setting, then click Edit next to the IP address range you wish to modify.
3. In the Subnet Edit window, define the range of IP addresses that will be searched
during discovery.
4. Select either of the following start modes:
For the MergePoint SP manager to automatically search for target devices in the specified IP
address range at the specified time interval, select Automatic. If you wish to repeat the
discovery sooner, click the Start link next to the IP address range.
NOTE: To set the time interval, see To set discovery time interval: on page 26.
- or -