Original Operating Manual 1-2013
34
Speed sensor check
The speed sensor (17) and the corresponding spoke magnet (18) must be mounted in such a
manner, that it allows the spoke magnet to pass during a revolution of the wheel in a distance
of 5 mm in minimum and no more than 17 mm, at the speed sensor.
Note: If the distance between the speed sensor (17) and the spoke magnet (18) is too large or
the speed sensor (17) is not properly connected, the speedometer at the Intuvia display will fail,
and the Hybrid bike will drive in default mode.
To fix this problem, loose the screw of the spoke magnet (10) and attach the magnet in a lesser
distance, on the speed sensor over-run. The best magnet position is near the B or H of the
BOSCH sensor label (points of higher sensitivity).
If there is still no speed displayed on Intuvia, please get in contact with your ave. dealer.
Switching the drive unit ‘on’ and ‘off’
