ATN MYGALE 23, Перевод с оригинала инструкции

Страница: 49 / 62

OPERATOR AND SAFETY MANUAL
1NO0040UK-01
Mygale 23
49
DANGER
IF THE ALARM SOUNDS, STOP ALL
OPERATIONS IMMEDIATELY.
RETRACT
THE TELESCOPE AND
FULLY LOWER THE PLATFORM. LEVEL
THE
MACHINE AGAIN BEFORE
RAISING THE WORK PLATFORM.
DANGER
DO NOT ACTIVATE THE EMERGENCY
STOP TO CUT THE ALARM AND
CONTINUE WORKING. FIRST UNLOAD
THE PLATFORM UNTIL THE ALARM
STOPS.
DANGER
NEVER PLACE ANY OBJECTS ON THE
TILT SENSOR.
5.1 TILT SENSOR
The tilt sensor located in the ground control
station compartment measures continuously the
machine’s tilt.
-
-NOTE-
This device must not guide how the machine
is used. Do not drive on inclines, uneven or
loose surfaces.

When the structure is driven, the indicator

lights up to indicate the machine is nearing
the maximum admissible slope.

When the structure is raised, the tilt light
comes on and an alarm sounds when the
maximum tilt authorised is reached.
The alarm indicates that the machine has
reached its stability limit.
5.2 LOAD CONTROL
When the permissible load on the work platform is
exceeded, the corresponding lights on the control
stations flash, an alarm sounds and all the
movements are stopped. The platform must be
partially discharged until the alarm stops.
If the overload was triggered by a collision with an
overhead obstacle, it is possible to clear the work
platform with the following procedure. This clearance procedure is solely reserved for this precise
case.
1- Turn the control station selector to ground controls.
2- Depress the enable button.
3- Within 10 seconds, control the desired movement (only telescopes in and arm lowering
movements are allowed).
4- If within 10s the platform is not cleared, repeat the desired movement (always with
validation and always within a 10s lapse of time).
5- Once it has been cleared, lower the platform. Check the good working condition of the
platform and of the load control device before resuming operation.