ATN MYGALE 23, Перевод с оригинала инструкции

Страница: 14 / 62

OPERATOR AND SAFETY MANUAL
1NO0040UK-01
Mygale 23
14

Inspection and controls before start-up.

Risks related to using the machine near overhead obstacles, other moving machines, holes,
obstacles on the ground and tilt.

Risks related to using the machine near conductors or powered electrical equipment.

Use of an approved fall-protection mechanism.

Safety requirements related to a task or specific use of the machine.
2.1.2 INSPECTION OF THE WORK PLACE

Before using the machine, the operator must take precautions to avoid any risk in the
workplace:

Locate the hazardous locations in the working area.

Locate the overhead obstacles, electrical lines, overhead cranes, cranes or other
elements.

Identify on the ground the presence of holes, bumps, tilt, debris and coatings likely to
hide holes or other dangers.

Check that the ground is able to support the load of the tracks and outriggers.

The machine must only be used in well-ventilated premises.

The machine must be used with sufficient ambient lighting.

The platform must not be raised if the machine is on the platform or trailer of a truck, on a
train, a ship or any other mobile or non-stabilised structure.

Do not operate the machine in hazardous environments unless approved for that purpose by
ATN.

DO NOT use the machine in presence of electromagnetic fields (radar, high voltage
currents…). This could damage the machine’s electronic components
TIPPING HAZARDS 2.2.

Never exceed the work platform's load capacity. Distribute the load evenly across the platform
floor.

Keep the load inside the work platform. Do not suspend a load from any part of the platform or
lifting structure. Do not place a load on the guard rail.

Check that the ground is able to support the load of the tracks and outriggers.

Do not drive the machine on slopes or tilts that exceed the maximum acceptable incline.

Do not raise the platform or move with the platform on inclines, hilly or loose surfaces. Always
make sure that the machine is on a firm and even surface before raising the work platform or
moving with the platform raised.

Keep the machine a good distance from holes, bumps, tilt, debris and coatings likely to hide
holes or other dangers on the ground.

Do not raise the work platform if the wind speed is greater than 12.5m/s (45km/h).