Installation
40
CV17 17" Modero Coor Video Touch Panels
7.
Carefully lay the separated LCD (from the main unit) onto a soft cloth resting on a level surface. This soft
cloth prevents scratching during the rest of the installation procedure.
8.
Insert the back box into the surface cutout to check for fit. Make any adjustments to the dimension of the
cutout to accommodate the back box.
9.
Cutout the notched beam (FIG. 41 on page 40) using a height of 13.554" (34.43 cm) and a depth
using
the following guideline
.
This notched beam is located on the side of the NXD unit furthest away from the
connectors.
Calculate the distance from the edge of the mounting ridge (FIG. 41) to the rear point (on the box)
where the beam touches the back box.
Our example uses
1 3/8" (inches)
(
on the deepest point of the rear back box
).
Calculate the thickness of the surface. Our example uses
5/8" (inches)
.
The depth of the notch: 1 3/8"
minus
5/8" =
6/8" (inches)
. This value reflects the cutout depth
necessary for the mounting ridge on the back box to be flush against the surface.
10.
Thread the incoming RJ-45, Ethernet, and any other audio/video wiring (from their terminal locations)
through the cutout opening. Refer to the
Wiring Guidelines for the 17" Panels
section on page 43 for
pinout descriptions.
Leave enough slack in the wiring to accommodate any re-positioning of the panel.
11.
Connect all data and power wiring connectors to their corresponding locations along the side of the (un-
powered) NXD touch panel.
Verify the terminal end of the power cable is not connected to a power supply before plugging in the
2-pin power connector.
FIG. 41
Wall Mount panel (NXD) installation using screws
B
- Main NXD unit consists of
the touch panel and housing
A -
Faceplate
(bezel)
Notching of one or more
stud beams may be
required if the unit is not
framed into the wall.
13.554"
(34.43 cm)
Install the four (#6)
Mounting Screws
into the holes
(
screws not included
)
Mounting
Tab
The determining factor in the depth of the cut into the beam is the thickness of the
surface.
The MOUNTING TAB MUST BE FLUSH
against the surface and therefore,
the depth of the notch depends on that thickness.
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the attached connectors before being inserted into the solid surface.
Содержание modero NXD-CV17
