Configuring Communication
61
CV17 17" Modero Coor Video Touch Panels
Master Connection - Virtual Master communication over Ethernet
Before beginning:
1.
Verify the panel has been configured to communicate either through an Ethernet cable (connected from
either the panel to a valid Ethernet Hub) or wireless to the Wireless Access Point.
2.
Launch NetLinx Studio 2.4 (default location is
Start
>
Programs
>
AMX Control Disc
>
NetLinx
Studio
>
NetLinx Studio 2.4
).
3.
Select
Settings
>
Master Communication Settings
, from the Main menu to open the Master
Communication Settings dialog (FIG. 58).
4.
Click the
Communications Settings
button to open the Communications Settings dialog.
FIG. 57
System Connection page
Obtained
from
NetLinx
Master
When configuring your panel to communicate with a Virtual Master (on your PC), the
Master IP/URL field
must be configured to match the
IP Address of the PC
and use
the Virtual System value assigned to the Virtual Master within NetLinx Studio.
FIG. 58
Assigning Communication Settings and TCP/IP Settings for a Virtual Master
IP Addresses of computer
(also obtained by using the
Start
>
Run
>
cmd
command)
Enter this IP
into the
Master IP/URL
field on the
System Connection
page
Содержание modero NXD-CV17
