AMX modero NXD-CV17, Руководство по эксплуатации/справочник

Страница: 67 / 168

Configuring Communication
57 CV17 17" Modero Coor Video Touch Panels
Shared Key Authentication requires that the panel and the Wireless Access Point have the same
WEP Key to authenticate.
8.
Toggle the Encryption field until it reads WEP64 or WEP128 . The 64/128 selection reflects the bit-level
of encryption security. This WEP encryption level must match the encryption level being used on the WAP.
9.
Toggle the Default Key field until the value matches the identifier value of the key entered into the
Wireless Access Point. Do not touch the Generate field.
10.
In the WEP Keys section, touch the Key # button to launch the WEP Key # keyboard (FIG. 56). This Key
value corresponds to the Default WEP Key number used on the Wireless Access Point and selected in the
Default Key field described in the previous step.
11.
Using this keyboard, enter the same Current Key value being used on the Wireless Access Point
(
characters only - colons are provided ).
12.
Click Done when you are finished entering the Current Key for the selected WEP Key.
13.
Verify the IP Settings section fields have been properly set. Refer to the Step 1: Configuring the Panel’s
IP Settings section on page 53 for detailed information.
14.
Press the Back button to navigate to the Protected Setup page and press the on-screen Reboot button to
both save any changes and restart the panel. Remember that you will need to navigate to the System
Connection page and configure the connection to a target Master.
15.
After the panel restarts, return to the Secondary Connection page to verify the Link Quality and Signal
Strength:
The Authentication field by default reads Open System .
WEP will not work unless the same default key is set on both the panel and the
Wireless Access Point.
For example: if you have your Wireless Access Point set to default key 4 (which
was 01:02:03:04:05), you must set the panel’s key 4 to 01:02:03:04:05.
FIG. 56 WEP Key # Keyboard
These keys must match for each key identifier on the target Access Point.
Ex: The Current Key string used by WEP Key 1 on the panel must match Current Key
string used by WEP Key 1 on the Wireless Access Point.
You can use up to four keys.
If your target Wireless Access Point does not support passphrase key generation and
has previously been setup with a manually entered WEP KEY, you must manually
enter that same WEP key on your panel.