14. If applicable – If not using the entire set of connectors that are available for
the signal, change the Starting Channel, Number of Channels to Create, and
Available Connectors as necessary.
15. Click Assign Signal.
16. Repeat Steps 13-15 until all of the signals in the Available Signals list have
been assigned to connectors, changing the values for the Starting Channel,
Number of Channels to Create, and Available Connectors as necessary.
17. Click OK.
The Manage Virtual Matrix Groupings dialog box opens again.
18. If applicable – If Mirror Directions was not selected in Step 12, repeat
Steps 11-17 for the outputs, selecting Destinations in Step 12.
19. Under Grouped Connectors, check the virtual channel assignment for each
connector by selecting the Source and Destination tabs.
20. Click Accept Assignments if satisfied.
The file is ready to be loaded onto the system; see page 8-9.
B-8
Epica-128 & Epica-256 Installation & Setup
Advanced Configuration: Modifying Virtual Matrices
Check connector assignments
Click Accept Assignments
Channel tabs
Advanced
Configuration
