Ametek Thermox WDG-1200 Insitu, Руководство пользователя

Страница: 58 / 100

4-16 | Thermox WDG-1200/1210 Insitu Probes
Probe type (SySt
↵
Prty)
To select the probe type:
Press enter
Select a value using the UP and doWn keys
Press enter again.
NOTE: The default setting corresponds to the Model
1200/1210 probe. Do not change this setting.
OPTIONS
Set probe type
RANGE
673 to 1172
DEFAULT
1023
Baud setting (SySt
↵
bAud)
To set the communications speed:
Press enter
Select one of the 4 options using the UP and doWn
keys
Press enter again.
NOTE: 96np is 9600 baud with no parity bit.
OPTIONS
[1200][4800][96np][9600]
RANGE
NOT APPLICABLE
DEFAULT
9600
Negative values (SySt
↵
nEg)
Negative values are not normally displayed but are
sometimes required for diagnostic purposes. The sys-
tem can be set to display negative values by press-
ing
enter
, selecting
Yes
using the
UP
key, and then
pressing
enter
again. Selecting
no
using the
doWn
key returns the display to normal.
OPTIONS
[NO][YES]
RANGE
NOT APPLICABLE
DEFAULT
NO
Probe address (SySt
↵
PrAd)
To set the probe address for the Modbus protocol:
Press enter
Select a value using the UP and doWn keys
Press enter again.
OPTIONS
Set probe address
RANGE
0 to 255
DEFAULT
11
Revision number of software (SySt
↵
rXXX)
The software revision number used in the analyzer
can be displayed by pressing enter . Example shown
is release 1.04.
OPTIONS
Display software revision number
RANGE
NOT APPLICABLE
DEFAULT
NOT APPLICABLE