Ametek Thermox CEM O2/TM, Руководство пользователя

Страница: 86 / 168

4-30 | Thermox CEM O2/TM
5. Select whether you want to enter the Alarm 4 set point using a percent
or PPM range.
You are then prompted to enter the Alarm 4 set point value:
Alarm #4 =xx
New Value?
6. Enter the Alarm 4 set point value.
7. Press the Cancel Key or the Enter Key to then exit this menu option.
Alarm Configure
This menu option allows you to define whether alarms should trigger
based on a high alarm or a low alarm condition.
Whether Alarm 3 is set high or low applies only if it is set to track
oxygen levels (% O
2
). If Alarm 3 is set to trigger at the start of a cali-
bration or verification, this option does not apply.
If you select Hydrocarbon Upset as the Sensor Config. option from the
Setup Key menu, Alarm 4 is fixed as both a high oxygen alarm and the
alarm that triggers during a hydrocarbon upset condition. In this case,
you will not be able to select Alarm 4 as a low oxygen alarm. Alarm 3,
however, can still be selected as a high or low oxygen alarm.
Configuring the alarms
1. Select Alarm Configure from the Alarm menu.
2. Define Alarm 3 and Alarm 4 as high or low alarms.
3. Press the Cancel Key to then exit this menu option.
NOTE
