Altigen ACM 6.7, Руководство администратора

Страница: 140 / 470

Triton T1/E1 Trunk Properties
126 MAXCS ACM 6.7 Administration Manual
Figure 59. Triton T1 Configuration dialog box
Following are the parameters for the Triton T1 Configuration dialog box.
Parameter Description
T1 robbed-bit signaling
Protocol
You can set Protocol to one of the following:
•
E&M Wink Start (default)
•
E&M Immediate Start
•
Ground Start
•
Loop Start
For signaling from one board to another, only E&M Wink Start is
supported. Loop Start, Ground Start, and E&M Immediate Start
protocols cannot be used for interfacing between two boards.
Dialing Delay Specifies the delay, in milliseconds, after trunk seizure and before
digit dialing. This configuration will slow down the system
transmitting digits to the CO by a defined delay to avoid missing
digits. Do
not change this value unless advised.
Caller ID and DID Collection
You can select the maximum time-out delays, in seconds, and the appropriate sequence
of symbols to be collected for Caller ID and DID.
Max. seconds
before the first
digit Maximum wait time before time-out for the system to identify this
digit after either the first
ring in ground start or loop start or the
wink in wink start. The range is from 1-6 seconds, or None , with
a default value of 3 seconds . Do not change this value unless
advised .
None means no Caller ID or DID information will be collected. All
other options will be grayed out. Use this option to disable Caller
ID and DID collection.
Max. seconds
between digits Maximum wait time before time-out between two digits. Default
value is
None . Do not change this value unless advised.
Selecting None means the system will only wait for the sequence
of digits that are collected within the length of time specified in the
Max. seconds before the first digit field.