If you wish to program another wireless transmitter, set the dipswitches 1-4 to the desired zone address, and
s
irm
e erase, the Happy melody will sound and the red zone LED will start flashing. To erase all ID codes at
ones of the wireless interface have been programmed, set the first four dipswitches to the module
ddress setting and set dipswitch 8 back to the OFF position. The RS-485 bus communication will now be
:
gs during programming
time 4 hours, OFF supervision time 2 hours.
w 7:
rted as “tamper” of the zone, OFF supervision disabled.
w 8:
ON, learn mode
a supervision alarm has
de, this LED is off.
):
nel
ED D2(RF):
flashes during reception of a PowerCode transmission
ZONE-STATUS
execute the learn procedure again.
When a zone was already occupied with an ID code, and a PowerCode transmission is initiated, a 3 second
alert tone is sounded. By shorting jumper JP4 during these 3 seconds, the ID code can be erased. To conf
th
once, set the zone address to address 0 (first four dipswitches to the ON position) and short jumper JP4.
When all z
a
resumed.
The dipswitch has 8 switches. The functions of each switch are as follows:
Sw 1-4
module address RS-485 bus (similar to I/O), zone address settin
Sw 5:
ON, AlphaVision NG (default), OFF AlphaVision 96
Sw 6:
ON, supervision
S
ON, supervision repo
S
OFF, function mode
The wireless interface has some LED’s. The function of the LED’s are:
LED-D13 (PWR):
when functioning, this LED burns or flashes. When it flashes,
occurred. When the wireless interface is in the learn mo
LED D12(COM
flashes during RS-485 communication with the control pa
L
LED D3-D10:
LED’s correspond with zones 1-8, indication as follows:
EVENT LED-INDICATION
ALPHAVISION
NG
upervision
LED
flashes
slow
Zone
supervision
During programming, the LED indications of LED’s D3 to D10 differ from the indication
entioned here above. When the zone is empty, the LED will flash, and when the zone is occupied, the LED
G
from the status’ shown in the display of a keypad connected to an AlphaVision
6 control panel. With the 96 control panel, low battery and supervision reports will be showed on the
wireless PowerCode transmitters using an RS-232 programming cable and a
ptop or PC with the Winterm or Termpriv software. Also the status and field strength of each PowerCode
3 to the
nnect the power, set all the
ipswitches to the OFF position and short JP4 to start the programming mode. The programming screen with
the input names and PowerCode ID codes will appear on your screen.
Alarm
LED
burns
Zone
alarm
Low battery
LED flashes fast
Zone low battery
S
Tamper
LED
burns
Zone
tamper
Attention:
m
will burn.
Note:
The zone status of the wireless transmitters as it is showed on the LCD display connected to an N
control panel, are different
9
display as tamper events.
Programming and diagnosing wireless transmitters with a PC
It is also possible to program
la
transmitter can be checked.
Make sure the power is disconnected from the wireless interface, and then place jumpers JP2 and JP
PC position (see text on circuit board). Connect the RS-232 cable between the PC and connector JP1 on the
circuit board and start up the Winterm or Termpriv software. Then reco
AlphaVision NG installation manual Rev. 2.0 27-08-2003 Blz. 66/101
d
