01: 111111 lev 4
ab...... SMTWTFS
Attention:
The characters representing the sections turn to lower case letters, and the characters representing
the days of the week now become capital letters. This means that the days are now selected and ready to be
edited. Again the keys <1> to <7> control the position of the characters. So, if user 01 is not allowed to arm
or disarm the system on Saturdays and Sundays, press <1> to change the first S to a dot (Sunday), and then
press <7> to change the last S to a dot (Saturday).
The display will change to:
01: 111111 lev 4
ab...... .MTWTF.
Now press the <#> key to confirm your settings. The capital letters MTWTF will become lower case letters:
01: 111111 lev 4
ab...... .mtwtf.
Now you have completed the programming of user code 01. You can press the <
↓
> key to scroll to user
code 02.
Attention:
The days are shown from Sunday to Saturday, since a week officially begins on Sunday and ends
on Saturday.
Attention:
To program 2-digit user codes enter the two digits you wish to use, and fill the other positions
with the number 0. So, if you want to program a 2-digit user code (e.g. 99), and you are using 6 digit user
codes, program your code as 990000. When you are using 5 digit codes, program the code as 99000. When
you are using 4 digit codes, program the code as 9900.
Using 2-digit codes is only possible with code
levels 0 and 1!
To erase a user code, program or edit the code as 000000.
By executing function 14 the main user (Attention:
only
the main user, so user code 98, can do this) can
print an overview of all programmed user codes. This will only work if a printer module is connected to the
AlphaVision NG control panel.
Attention:
To edit user code 98 (main user), function 6 has to be executed with user code 98. All other users
with code level 5 and also the installer code cannot edit user code 98.
Program proximity keys with an LCD/Prox keypad
Programming and changing proximity keys is similar to programming or changing regular user codes on an
LCD keypad.
Press <?> <6> <#> followed by a level 5 user code (main user).
The display will now prompt you with: "
Enter number of usercode: -
". Type in the number
(location) of the user code you wish to edit or program (01..98) or press <#> to jump to the first user code
(01). The display will change to:
01: 000000 lev 0
abcdefgh smtwtfs
Now press the <#> key to start changing the programming. The display will show:
AlphaVision NG installation manual Rev. 2.0 27-08-2003 Blz. 60/101
