Allied Telesis AT-FAN08, Руководство по установке

Страница: 156 / 214

Chapter 6: Configuring Switches for Stacking
156
Powering Off the Switch
After performing the previous procedures in this chapter to confirm the
hardware operations of the switch and configure the device for stacking,
perform the following procedure:
1. Power off the switch by doing one of the following:

If it has AC power supplies, disconnect the AC power cords from
the AC power sources.
 If it has AT-SBxPWRSYS1-80 DC Power Supplies, power off the
On/Off switch on the power supplies. Refer to Figure 63 on page
111.
2. Repeat the procedures in this chapter on the remaining switches to
configure them for stacking.
3. After configuring all the switches, confirm that they are all powered off.
4. Review the following items:
 Do all the switches have the same version of the AlliedWare Plus
operating software? If not, update them before continuing, Refer to
the Software Reference for SwitchBlade x908 GEN2 Series
Switches for instructions.
 Do all switches have the same optional licenses? If not, refer to the
Software Reference for SwitchBlade x908 GEN2 Series Switches
for instructions.
5. Cable the trunk ports on the switches. Refer to Chapter 7, “Cabling the
AT-XEM2 Line Card Ports” on page 157.
6. Power on and verify the stack. Refer to Chapter 8, “Powering On and
Verifying the Stack” on page 167.
7. Cable the networking ports on the switches. Refer to Chapter 7,
“Cabling the AT-XEM2 Line Card Ports” on page 157.