ALGE-Timing TDC8001, Руководство пользователя

Страница: 10 / 112

Manual
TdC 8001
-10-
2 Getting Started
2.1 Power Supply
The TdC8001 has an integrated battery pack. The battery pack consists of six welded NiMH cells. It can
be charged with an
ALGE
charging device PS12 or a 12 volt car battery. The charging voltage must be
in between 11 and 16 Volt with the device switched on.
2.1.1 Charging Device PS12
The TdC 8001 can be charged directly from the mains (100-240VAC/50-60Hz) with the charging device.
- Connect PS12 to mains
- Connect PS12 at the jack „extern supply“ (A’) or „photocell“ (A, B or C)
- Turn on TdC 8001 (ON / OFF switch g)
- Red LED (2) must glow
- The TdC 8001 must be turned on during charging so that the internal charging electronic works.
- The TdC 8001 can be charged during normal timing operation.
- Charging time with PS12 is approx. 12 hours
- Open circuit voltage of PS12 is 15 volt
- Charging voltage of PS12 is 11.7 volt
Important: The batteries are not charged when TdC 8001 is turned off!
2.1.2 External Battery (12 V Car Battery)
Every battery with a voltage of 12 volt and a power of at least 5 Ah can be used for charging and sup-
plying the TdC 8001.
- Connect cable 005-02 to jack „extern supply“ (A’)
- Connect automotive clip (+) at positive pole of the battery
- Connect automotive clip (-) at negative pole of the battery
- red LED (2) at TdC 8001 must glow
2.1.3 Operating Time
The battery status is continuously indicated with the meter (3). As long as the indicator of the meter is
in the green area, the TdC 8001 can be operated.
2.1.4 Charge Condition of the Battery
The TdC 8001 has six NiMh batteries with 1.2 volts and 4.5 Ah each. The voltage of the batteries can
be shown in the info display (7) at any time by pressing the key <TEST>.
The voltage of the batteries is automatically checked and so a warning is shown in the info display (7)
in case the batteries become empty.
Pre Warning : The display shows “nearly empty batteries”. The voltage is 6.8 volts.
You can continue to work until a voltage of 5.8 volts. If possible, the charging device
PS12 or an external 12 volts battery should be connected.
Shutdown : The display shows “empty batteries”. The voltage is 5.8 volts.
If a voltage of 5.8 volts is reached, the TdC 8001 automatically shuts down into stand-
by. This is necessary for keeping the memory. Work can only be continued if the battery
is charged with a charging device or an external battery. The TdC 8001 does not have
to be re-synchronized.