Operation
24
www.einhell.co.uk
AFTER SALES SUPPORT
24
GB IRE
GB
IRE
0044 151 649 1500
0044 1890 946 244
Parallel guide
Stop height
The stop rail
10
for mounting on the parallel guide
33
has two guide surfaces of
different heights. Depending on the thickness of the materials to be cut, turn the stop
rail into an upright position for thick material (work piece thickness over 25 mm) and
into a flat position for thin material (work piece thickness under 25 mm).
To turn the stop rail:
1. Loosen the knurled nuts of the parallel guide by turning them a few revolutions.
2. Pull the stop rail off of the parallel guide.
3. Turn the stop rail to the desired position.
4. Push the stop rail onto the parallel guide so that the squares of the two carriage
screws slide into the profile of the stop rail.
5. Tighten the knurled nuts to fix the stop rail on the parallel guide.
Cutting width
When cutting pieces of wood lengthwise, use the parallel guide
33
that should be
mounted on the right side of the saw blade to the extent possible.
A scale with black print and a scale with blue print are located on the rail
45
on the
front of the saw table. They indicate the distance between the stop rail and the saw
blade (cutting width):
• Use the scale in
black print
if you have mounted the
stop rail in an upright
position
(for thick material).
• Use the scale in
blue print
if you have mounted the
stop rail in a flat position
(for thin material).
Proceed as follows to set the parallel guide to a certain dimension:
1. Lift the eccentric lever
31
.
2. Push the parallel guide until the desired dimension is visible on the scale in the
viewing window
32
.
3. Push the eccentric lever all the way down to lock it.
Setting the stop length
To avoid clamping the material to be cut, the stop rail
10
can be moved lengthwise.
Rule of thumb: The back end of the stop runs into an imaginary line that roughly starts
from the middle of the saw blade and runs to the back under 45°.
1. Set the required cutting width.
2. Loosen the knurled nuts on the parallel guide
33
by turning them a few
revolutions.
