82
B l e e d and S lug opt ions
Use Document Bleed Settings:
Applies the bleed values specified in Document Setup instead
of specifying them here.
Bleed:
specifies the amount of bleed on each side of the page. The four options are labeled
Top, Bottom, Left, and Right when Spreads is selected or Facing Pages is deselected in the
Document Setup dialog box. The options are labeled Top, Bottom, Inside, and Outside when
Facing Pages is selected. If you want to specify the same value for all sides, click the link icon
(
) to make all four values identical, then enter a value in any box.
If page marks are on, they are always printed even if a bleed value is zero, because the bleed
value only affects how far objects on the layout print beyond the page edge. However, when
bleed is set to zero, trim marks and bleed marks may be indistinguishable because they will
print on top of each other.
Include Slug Area:
Adds the slug area (specified in Document Setup) to the total output area.
When deselected, the slug isn’t printed—the job will print to the edge of the bleed area.
