Acadia AH3024FP, Руководство пользователя

Страница: 39 / 92

39
instructions. Be sure all items in lighting and installation checklists are completed.
4. Periodic visual check of pilot flames is required. Pilot flame must overlap flame sensor and burner ignition ports always.
Especially for LP gas applications, always verify visible pilot flame length is at least 1” long.
5. Periodic visual check of the burner flame is required.
What Should I Do If Sooting Occurs?
Troubleshooting Soot
Issue Possible Causes Corrective Action
Thin black coating (soot) forms
on viewing glass
• Incorrect gas pressure
• Not enough combustion air
• Leaking glass gasket
• Vent obstruction
Have gas supplier check for correct gas inlet pressure
(7" WC nat. gas; 11" WC LP gas). Check the glass
gasket for proper seal. Corners of glass gaskets cannot
be bulging out. If glass gasket along the top edge in
the middle is white in color across entire thickness of
gasket bulb, replace glass gasket.
If sooting continues, open air shutter on burner. If
sooting continues, shut off and call an authorized
service person.
Sooting is caused by improper installation or air shutter operation. However, some small areas of soot deposits on log surfaces
are deemed acceptable. If you observe large soot areas (larger than 1”x1”) on log surfaces or signs of sooting on the door
glass (usually a thin black film on the viewing glass or on the outside of the home around the vent cap), turned off immediately
and the local authorized dealer promptly informed. Authorized dealers will correct “sooting” problems, but they are not
responsible for damage caused by excessive sooting that has not been immediately brought to their attention.
How Do I Change From °C to °F On My Remote?
To change between °C to °F, follow these steps:
1. Press the ON/OFF button and turn off.
2. Simultaneously, press both the mode button and the thermostat button.
3. Look at the LCD display to verify that your desired indicator (°F or °C) is being displayed. If not, repeat Step 2.
How Do I Set The Child-Lock Mode?
To prevent unsupervised children from operating, a child-lock function is provided with this remote-control system.
To activate the child-lock function: Simultaneously press the “MODE button” and the “UP button”.
To deactivate the child-lock function: Simultaneously press the “MODE button” and the “UP button”.
During the child-lock mode, none of the remote-control buttons will function. You must deactivate the child-lock function
before you can use the remote control.
When Should I Change The Batteries In My Remote?
When the remote-control batteries are low, a battery icon will appear on the LCD display of the remote control before all
battery power is lost. When the batteries are replaced, this icon will disappear.
Why Did My Thermostat Disappear From My Remote?
When reinstalling batteries, the thermostat may have been pressed while the batteries were changed. To make your
thermostat reappear, follow these steps:
1. Remove one battery.
2. Press and hold the thermostat button on the remote.
3. Reinstall the battery while holding the thermostat button down.
4. If you see “set”, the thermostat button is now enabled.
5. If you see “clear”, the thermostat button is disabled.
6. Repeat this procedure if you did not see “set” or “clear” to add/remove the thermostat option.
Why Won’t It Turn On?
If your remote control is working, but your appliance won’t turn on, it may be in “lockout” mode. To reset a lockout follow
these steps:
1. Turn off remote.
2. Turn on remote and wait 2 seconds.
HOMEOWNER OPERATION