Acadia AH3024FP, Руководство пользователя

Страница: 38 / 92

38
Additives that are put in gas (both natural and LP) to make it smell can be harmful to glass and can leave
a white film deposit on the glass. This deposit can be removed with cleaners such as KEL KEM “Polish Plus”
or comparable product. Contact your authorized dealer for more information.
HOMEOWNER OPERATION
IMPORTANT
Do not use oven cleaner or ammonia-based products to clean glass. Clean the glass only
when it has cooled to room temperature.
How Do I Clean The Glass?
The glass should be cleaned periodically.
To clean glass surface, use Kel Kem Polish or a comparable product. Do not use oven cleaner or abrasive cleaners to clean
glass. Do not clean when glass is hot.
Is My Flame Appearance Correct?
There are air shutters, coals, and embers that can be adjusted depending on your fuel and venting configuration. These
adjustments should be made by a qualified technician to achieve the best flame appearance. Contact your installer or
authorized dealer if you feel it is not burning correctly. Improper setup and adjustment is not covered under warranty.
Follow these steps for periodic inspections:
1. Check to verify that the vent system and vent cap are open and free of blockage.
2. The glass should be cleaned periodically (see the “How Do I Clean The Glass?” section of this manual).
3.
Before re-installing glass, have qualified service person check the operation of the pilot and cycle the burner per lighting
Flame Characteristic Cause Solution
Dark, orange flame with
black tips
Venturi closed too far Open venturi slightly
Short, blue flames Venturi open too far Close setting slightly
Lifting (ghosting) flames
Gas pressure too high
Venturi closed too far
Check manometer settings
Open venturi setting slightly
No Blue
Flame Center
Dark Orange
Flame
Soot At
Flame Tip
Soot Above
Flame Tip No Soot at
Flame Tip
Semi-Transparent
Yellow Flame
Blue Flame
Center
Ports On Pan
Burner Assembly
PROPERLY
BURNING FLAME
BURNER FLAME APPEARANCE
IMPROPERLY
BURNING FLAME
Flame
Sensor
PROPER PILOT FLAME
APPEARANCE
3. Check condition of glass door gasket, the gasket must seal tightly over firebox, Inspect gasket along top and sides of glass.
If gasket at corners of glass are bulging outward or if gasket bulb along top edge or sides are discolored to a white color
appearance through the whole thickness of the gasket bulb, then replace the gasket. White colored gasket bulb indicates
exhaust leak through the discolored area and requires replacement of the glass gasket.