ABB IRC5P, Руководство по эксплуатации продукта, Страница: 47 / 220

5 Installation and Commissioning
Product Manual, Control Cabinet IRC5P 3HNA009834-001 en Rev.06 47
5.2 Component Installation
5.2.2 Lifting and Transporting the Controller
General
The control cabinet is shipped on a transportation pallet at an upright position.
Weight of the control cabinet is given in ’Controller Specifications’ on page 32.
Figure 20 Control cabinet lifting
Procedure
This procedure describes how to lift and transport the control cabinet.
WARNING!
Attach the top of the cabinet to the fork lift using a strap or similar to
prevent it from tipping over by braking etc. See Figure 20 , lower left illustration.
1. After having unloaded the control cabinet crate from the lorry, use a fork lift
and transport the cabinet to the installation site or as close to the site as possible
before removing it from the pallet.
2. Unpack the supplied packages and check that the content is correct and
undamaged.
3. Place the cabinet on the floor and remove packing material.
WARNING!
Do not walk under the hanging load.
4. Transport the cabinet to its permanent location using an overhead crane or fork
lift. See Figure 20 , lower left and right illustration.
CAUTION!
If lifting straps are used, they must be attached to all 4 lifting eyes.
For information on location of the cabinet and information on how to secure the
cabinet to the floor, etc., see ’Cabinet Location’ on page 48.
Lifting eyes
Min. 45°
Lifting by
fork lift
Max. 17.5°
Safety strap
Transporting cabinet by fork lift
Lifting by
overhead crane
Lifting strap attachment to hook
Center
of gravity
Lifting the cabinet
1 meter