ABB HVC-R 100, Руководство по установке, Страница: 92 / 131

HVC-R 100/150 E-Bus Charger Installation Guide
Document: v0.4 / Document No.: TBA | Date: 11-08-2021 Page 92 of 131
WARNING
In case the Pedestal is used, the PE wire from the Power Cabinet must
be connected first to the GND point of the Pedestal. See
Install lighting protection (optional) on Page 93.
5.14.4. Connect the external PE wire

PE may be connected from locally available ground connection in the vicinity
of the Dual Depot Charge Box

PE may be routed from Power Cabinet or distribution board via cable conduits.
In that scenario each Dual Depot Charge Box should have dedicated PE cable.
Prerequisites:

Tools: wire cutter, wire stripper pliers, ferrule, crimp pliers, screwdriver
Location of PE connector block X8-1 and the preferred cable route.
1. Loosen and remove the cable gland’s (#11) nut for the PE wire.
2. Slide the cable gland’s nut over the PE wire.
3. Route the PE wire (B) through gland #11 to the PE connector block X8-1. Refer to the
figure above for the preferred cable route through the cable duct inside the cabinet.
4. Cut the PE wire to the correct length to reach the PE connector block X8-1. Do not make
the wire routing too tight, or too loose.
5. Tighten the nut of the gland to secure the PE wire.
6. Strip 11 mm of the insulation from the end of the PE wire (B).
7. Crimp a ferrule (A) to the end of the PE wire (B).
8. Loosen the connector screw of the PE connector block X8-1.
9. Insert the PE wire (B) into the PE connector block X8-1.
10. Tighten the screw of the connector block with a tightening torque of 1.3 Nm.