ABB HVC-R 100, Руководство по установке, Страница: 82 / 131

HVC-R 100/150 E-Bus Charger Installation Guide
Document: v0.4 / Document No.: TBA | Date: 11-08-2021 Page 82 of 131
Next steps are only applicable if the Dual Depot Charge Box is to be installed on a pedestal.
6. Unpack the pedestal.
7. Remove the cover of the wooden box.
8. Lift the pedestal out of the box.
9. Place the pedestal on a
secure surface with its top facing up.
CAUTION
To prevent damage to the paint layer of the pedestal, always place the
pedestal on a secure surface that provides sufficient protection against
scratches and other damage.
ABB is not responsible for any damage caused to the pedestal during its
unpacking.
10. Remove all protective foam from the pedestal.
5.12. Installing the Dual Depot Charge Box onto a Pedestal
5.12.1. Connecting the Pedestal to the Foundation
Prerequisites:

All packaging material is removed from the Pedestal.

A minimum of two people is required.

Tools: torx screwdriver (size T30), spanner (size 19).
1. Remove the front cover plate (A) from the Pedestal (B) by loosening the bolts (C) (8x).
2. Put the front cover plate (A) and the bolts (C) in a safe location as they will be installed
back later on.
Removing the pedestal’s front cover plate.
3. Remove the rear cover plate (H) from the Pedestal (B) by loosening the bolts (G) (6x).
4. Put the rear cover plate (H) and the bolts (G) in a safe location as they will be installed
back later on.